Welcome to the Kurt J. Lesker Company.  

Sign In | Register

Current Region: International (Change) | Contact Us |   RSS   Twitter   LinkedIn   YouTube

Close

Please select your country or region to be
directed to the appropriate Lesker site.

Nickel/Chromium (Ni/Cr 60/40 WT%) Pieces Evaporation Materials

Overview

We sell these pellets and pieces by unit weight for evaporation use in deposition processes. These approximate materials prices are published to provide budgetary guidelines. Actual prices can very and may be higher or lower, as determined by availability and market fluctuations. Contact international@lesker.com for current pricing.

Fill Rate Calculator

Instructions for use:
Input the Crucible Liner Volume, Select Material (if not available in menu, manually input Material Density in g/cm3), and input fill rate %.

KJLC recommends a fill rate between 67-75%. Overfilling the crucible will cause the material to spill over and create an electrical short between the liner and the hearth causing the crucible to crack. Placing too little material in the crucible or allowing the melt level to get too low can be detrimental to the process as well. When the melt level is below 30%, the e-beam is likely to strike the bottom or walls of the crucible which immediately results in breakage.

The fill rate above assumes that the material is fully melted and does not take into account packing density. It should be noted that the crucible liner may need to be loaded multiple times, pre-melted, and topped off in order to achieve the final desired melt level/fill rate. When loading the crucible, do not load more than 80% of the height of the crucible liner.

This calculator is for estimation purposes only.



Crucible Liner Volume:
 (in cc)
Material:

                             - or -
Enter the density of the material in g/cm3:
Fill Rate %:

Result

See highlighted results that match your result in the table below.


Material Needed to Deposit a 1 Micron Film Calculator

Instructions for use:
Input distance from source to substrate and Select Material (if not available in menu, manually input Material Density in kg/m3).

This calculator is for estimation purposes only. It is calculated based on the source to substrate distance as the radius of a hemisphere, calculating the area of that hemisphere, and applying the density of the material and desired film thickness to that number (1 micron in this case).



Distance of source to substrate:
(in cm)
Material:

                              - or -
Enter the density of the material in kg/m3:
Multiplier:
Mass for 1 micron layer


SDS
Click here for the Nickel/Chromium SDS.
Request A Quote
Can't find the size or material you need? Please use our Materials Quotation Form to request.
Deposition Materials FAQ
Click here for answers to some of the most common questions we get asked.
Contact Us
To speak with someone directly, please call 1-412-387-9200 or email international@lesker.com.

Ordering Table

Material Size Quantity Purity Part # Price Add To
Cart
Material Size Quantity Purity Part # Price Add To
Cart
Clearance Item Nickel/Chromium 3mm - 12mm Per Gram 99.90% EVMNICR303-12X P.O.R.
Note Clearance Item = Limited availability and specially priced.

 

Kurt J Lesker Company Logo

Buy Online or Call
+1 412 387 9200

ISO:9001 The Kurt J. Lesker Company is an ISO:9001 certified company. Copyright ©1996-2017 Kurt J. Lesker Company® All rights reserved.